Plug a Fuse Buddy Current Loop into a circuit and now you can clamp your current probe over the wire to read the amperes draw.

Flexible 1.5 inch silicon pins provide easy back probing connections for DMM and scope measurements. These have become very popular for use in diagnostic troubleshooting. They are especially handy for back probing harness connectors in difficult areas. These can be used up to 30 Volts DC with most t...

Dva adapter - for use with your digital Multimeter. This is the "original" direct voltage adapter supplied to several OEM's for reading peak voltages on CDI ignition systems. This is an essential tool for diagnosing ignition systems on outboard engines and other similar small engines. The adapter pl...

Plug a Fuse Buddy Current Loop into a circuit and now you can clamp your current probe over the wire to read the amperes draw.

Relay Buddy is a quick go/no-go tester for the most common automotive relays. It provides you with an indication of the general health and functioning of the relay switch contacts and coil. Relay Buddy will check the control side of the relay by applying a signal to the relay coil while it checks fo...

LOADpro performs voltage drop test with the push of a button. On a 12 Volt system, pressing the switch applies a load of approximately 0.5 Amps across the circuit. This simple test finds problems in corroded wires/connections and shorts to ground. It works with your existing DMM.

Great for use on a wide variety of engines, including outboards, snowmobiles, motorcycles, small engines, generators, lawn equipment, ATV, automotive and more.